| Author |
Message |
ACE
Ree-Yees
Joined: 10 Nov 2007
|
 Posted: Dec 20, 2007 04:10 Post subject: A Problem............ |
   |
|
Hi, got a problem that i dont know how to fix. when ever I test my level and i go into one of my sectors theres an invisible wall that prevents me from going to that sector. How do i fix it,and whats causing it?
|
|
Pumpkinetics
Ree-Yees
Joined: 16 Oct 2007
|
| Posted: Dec 20, 2007 06:07 Post subject: |
|
|
It's possible you accidentally turned on the wall flag "cannot walk through wall". Check the flags on the offending wall.
Beyond that I'm useless in this field.
_________________
"So, how goes (X) ?"
"WORKIN' ON IT! I SWEAR!" |
|
ACE
Ree-Yees
Joined: 10 Nov 2007
|
| Posted: Dec 20, 2007 23:36 Post subject: |
|
|
ok,tried it and looked but it didnt fix it.Thanks though
|
|
Nottheking
Kell Dragon
Joined: 29 Sep 2003
|
| Posted: Dec 22, 2007 02:13 Post subject: |
|
|
This happens occasionally, and I think is a glitch... As I recall, if you try to enter it, you just get "stuck," rather than pushing and sliding along the sector boundary like you would if it was a wall?
AT THE MOMENT, I can't recall what causes that. Though I do recall that personally, most of the time when it happens I just delete the offending sector and make it over again.
_________________
Wake up, George Lucas... The Matrix has you.. |
|
Fenwar
Admiral Ackbar
Joined: 15 Sep 2003
|
| Posted: Dec 23, 2007 10:54 Post subject: |
|
|
The other thing that can cause this is two overlapping vertices. Cycle through them one by one and see if any are at the same coordinates?
|
|
Patrick Haslow
Trandoshan
Joined: 25 Sep 2003
|
| Posted: Dec 23, 2007 15:17 Post subject: |
|
|
Fenwar is right. Its gotta be some overlapping vertices.
|
|
The MAZZTer
Death Star
Joined: 25 Sep 2003
|
| Posted: Dec 23, 2007 22:53 Post subject: |
 |
|
Yeah it sounds like some sort of geometry problem. If you can't figure it out try deleting and remaking the offending sector from scratch. Overlapping verticies is the only thing I can think of that could cause it though.
_________________
http://www.mzzt.net/ | I am a respectable admin with a respectable sig. |
|
DF Veteran
Ree-Yees
Joined: 24 Nov 2005
|
| Posted: Dec 27, 2007 03:32 Post subject: |
|
|
Yah, I get that when the vertices on a door are not at the same coordinate.
I was editing a level once and I would try to walk throught the door then get stuck. I could teleport into the room, but I could not move at all, not even turn around. I exited DF, looked in the editor and found that either one or both of the vertices for that door were less than 0.5 off from the connecting vertices in the extrusion. I alligned them on the same coord. and that fixed it.
|
|
|
